User Manual

ADCP-XX-XXX • November 2000 • Section 4: WMTS Installation
Page 4-6
 2000, ADC Telecommunications, Inc.
2.3 Connecting the Front Panel
Connect the switched hub Port 1 via 100BaseT cable to the RJ-45 connector on the front of
the control and forwarder (C&F) card (see Figure 4-4). The card closest to the host card is the
C&F card.
14189-B
100-BaseT
Universal
Power
Cnt,
Fwd.
Dwnstr.
Upstr.
100M
Lan OK
Active
100-BaseT
Hot Swap
Com1-RS232 Com2-RS232
Figure 4-4. WMTS Control and Forwarder Front Panel Connector
2.4 Extracting and Inserting Cards
1. Push the power switch off.
2. Disconnect any cable connected to the cards on the front and the rear.
3. Unscrew the two screws (at the top and button) and extract the card with care from the
slot.