Installation Manual

General Installation Information

10 750.001.003

Revised June 1999

Inc.

Hand Tools, Equipment and Materials

IMPORTANT! You need to have the following materials on hand to

ensure successful installation of the NT132 system.

These items are not supplied with the NT132 System.

Required

• RG-58/U coaxial cable with 50-ohm impedance (nominal), solid

copper center conductor, 55% tinned copper braid or better,

100% foil shield coverage (for example, Belden 9310). The

length required for your installation will vary.

• Eight 3-Piece Crimp Type Male BNC Connectors (for example,

Amphenol 31-320). Connectors can be damaged during

crimping. Having more than eight on hand is recommended.

• Tape measure

• Power drill and bits

• Diagonal cutters

• Phillips and flathead screwdrivers, including a very small flathead

screwdriver

• 4 # 10 Anchors, Plastic (for mounting the Reader in drywall or

mortar)

• 4 # 10 Self threading screws

• 4 # 10 Washers

• 4 Screws for mounting the ATU

• Wire strippers

• Three blade rotary coaxial cable stripper

• BNC crimpers

• Multimeter

• Wire to connect to third-party devices (i.e., camera, door strike,

etc.) as specified by the manufacturers.

• A computer to configure the Reader ID numbers

• A terminal communication program

• A straight-through (one-to-one) DB9 male to female serial cable.

DO NOT use a null-modem cable or a null-modem adapter.