Installation Manual

Reader Installation

20 750.001.003

Revised June 1999

Inc.

• External DB9 RS-232 female connector to connect to a computer

or device

• Conduit chase for wiring access through the Reader case

• White terminal block with connections for Wiegand ground, Data

One and Data Zero, and connections for 24V power and ground

• RJ45 connector used by AXCESS for programming the Reader’s

firmware

Reader Types

Serial Reader

This type of Reader can interface directly with the communications

port of a computer or another control device that process standard

EIA-232 serial data.

Wiegand Reader

This is type of Reader outputs standard SIA 26-bit Wiegand data and

is used when interfacing with a standard Wiegand controller.

For each Tag read, the Reader outputs data every 750 milliseconds.

Duplicate Tag information is stored in the Reader’s buffer for 12

seconds so that redundant Tag reads are ignored during the this time

interval.

FTT Readers

FTT (Free Topology Transceiver) Readers are for installations

involving a network of Readers connected to one another. This is

accomplished via twisted-pair wiring over a total distance of up to

8,800 feet. FTT Readers can also control devices according to data

sent over the network by the host computer.

Required Materials

The following materials are necessary for a successful installation:

• Power drill and bits

• Screwdrivers – Phillips and flathead

• 4 # 10 Anchors, Plastic (for mounting in drywall or mortar)

• 4 # 10 Self threading screws

• 4 # 10 Washers

• Depending on the surface that the Reader will be mounted on,

you may need #10 molly bolts.