Installation Manual

Reader Installation

Inc. 750.001.003

Revised June 1999

Step 1: Ensure that the 110 AC outlet is near the Reader and is

easily accessible.

Step 2: Open the Reader case and disconnect the BNC connector

running from the Transmitter card at the TX connector

(Figure 6). This will give you access to the terminal block

underneath.

Step 3: Loosen the white terminal block by unscrewing it. This will

give you access to the terminals.

Step 4: Run the power wires through the conduit chase.

Step 5: Insert the positive 24V wire into the terminal labeled 24V

(Figure 13).

Step 6: Insert the ground wire into the terminal labeled G.

Step 7: Screw the white terminal block down.

Step 8: Reconnect the TX cable connector.

Step 9: Plug the AC adapter into a 110 outlet.

When power is supplied to the Reader, the LEDs on the card stack

will light up.

Note: The open terminals on TB1 are for future enhancements.

IMPORTANT! The Reader comes with a factory-default ID number

that needs to be changed to eliminate the possibility of cross talk.

See the section Configuring 3.x Reader Firmware, page 35.