Installation Manual

Configuring 3.x Reader Firmware
36 750.001.003
Revised June 1999
© 1999 AXCESS
TM
Inc.
RS-232
RS-232 cable
attached to the
output card.
The red wire is
closest to the
Reader case.
Figure 15 FTT Reader with the output card disconnected from
the FTT motherboard and connected to the RS-232 port.
Step 4: Attach the DB9 male connector of the RS-232 cable to the
external RS-232 port on the Reader.
Step 5: Attach the other end of the RS-232 cable to the computer.
Remember: When you have finished communicating with
the Reader, detach the 9-wire ribbon cable from the output
card, reattach the 10-wire ribbon cable from the FTT
motherboard to the output card and detach the computer
from the Reader.