Installation Manual

Tag Mounting

80 750.001.003

Revised June 1999

Inc.

Step 6: IMPORTANT! Ensure that the Tag can be read by the

Reader when the laptop is carried normally through the

transmit field. In addition, place the Tag on the laptop

where it cannot be easily pried off or removed. Do not

place the Tag on a removable surface (i.e., battery cover).

Step 7: Once a location is found, use a pencil to trace around the

edge of the LED Test Tag.

Step 8: Use a cyanoacrylate adhesive (for example, ProCement

from ProTec Technology). Practice the following steps with

similar materials of lesser value until the proper amount of

adhesive and application pressure is established.

Step 9: Closely follow the instructions provided with the adhesive

kit. You may have to lightly sand the surface inside the

marked area if the asset is painted or has a protective

surface applied.

Step 10: Wearing latex gloves, thoroughly clean the sanded area

with the supplied isopropyl alcohol pad.

Step 11: Carefully apply adhesive to the back of the Tag that will be

bonded to the asset. Ensure a continuous bead close to

the edge, but not so thick that the excess will ooze beyond

the edge once the Tag is positioned.

Step 12: Carefully position the Tag onto the marked area of the

asset, applying pressure for the time specified in the

instructions.

Note: Only an extreme level of prevention is a guarantee against loss

or damage at the hands of a determined thief. However, when assets

are tagged as described here, they will remain tagged for tracking

purposes even under heavy industrial or business usage.