User's Manual

ManualsBrandsAxcess International ManualsElectronicsAT132-AT Activator

Table Of Contents

General Installation Information
- Safety
- Information Flags
- Hand Tools, Equipment and Materials
  - Required
  - Recommended
A
ActiveTag System Overview
- ActiveTag System Components
- Tags
- Activator
- Receiver
- Transmit Antennas
  - Types of Transmit Antennas
System Configuration Basics
- Introduction
- Application Types
  - Vehicle
    - System Placement Guidelines
  - Personnel and/or Asset
    - System Placement Guidelines
- Multiple Activator Applications
- Installation Tips
- Basic Installation Steps
C
Configuring and Installing the Activator
- Introduction
  - Activator IDs
- Supplying Power
- Setting the Activator ID
  - Method 1: Serial Commands
  - Method 2: Hardware
- Other Serial Port Commands
- Activator Installation
  - Required Materials
  - Mounting the Activator
- Resizing the Activation Field
  - Adjusting the Field
C
Configuring the Receiver
- Introduction
- Connecting Power to the Receiver
- Configuring the Receiver
- Receiver Responses
- Setting up a Wiegand System
  - Responding to Activator IDs
  - Alarm Output
- Setting up a Serial or LAN System
- Setting the Receiver ID
- Enabling TTL outputs (Logic Control)
- Diagnostic Mode
  - _
  - Turning off Diagnostic Mode
- Viewing Configuration Settings
C
Configuring the NIU
- Introduction
- Connecting the NIU to the PC
- Setting up the Serial Port
- Connecting the Receiver and the NIU
- Modifying the NIU Configuration
I
Installing the Receiver
- Connecting to a Wiegand Control Panel
  - Wiegand Output
- Connecting to a Serial Device
  - Serial Output
- Wiring TTL Outputs to TTL outputs
- Connecting to the NIU and the Network
- Mounting the Receiver
  - Mounting the Receiving Antenna Separately
Road Loop Antenna Installation
- Introduction
- Required Materials
- Prerequisite Tasks
- Road Loop Layout & Connecting to the Activator
- Installing the Road Loop Antenna (Frequently contracted)
B
Bar Antenna Installation
- Introduction
- Prerequisite Tasks
- Installation Considerations
- Installing the Bar Antenna
P
Picture Frame Antenna Installation
- Introduction
- Prerequisite Tasks
- Installing the Picture Frame Antenna
T
Tags
- Types of Tags
- Tag Labeling
- The LED Test Tag
- Mounting Tags to Assets
- Mounting Tags to Vehicles
- Tags and Personnel
  - Required Materials
  - Operating Panic Tags
Appendix A: Troubleshooting the System
- _
A
Appendix B: Coaxial Cable
A
Appendix C: Advanced Wiegand Configuration
- _
  - Setting the Time between Outputs
  - Changing the Duplicate Tag Buffer
Appendix D: Receiver Commands
Appendix E: Specifications
- _
I
Index

System Configuration Basics

Receiver

The Receiver (Figure 3) has the following functions:

• Decode the signal received from the Tag via the receive antenna.

The Receiver converts the data to a format usable by a computer

or Wiegand control panel for further processing of the

information.

• Filter Tag information according to its configuration settings.

• Send the data to a control device or a computer.

• Output control signals for activating TTL outputs or alarm points

on panels.

PWR LF

UHF

RX TX

DATA

AUX

RX TX

ActiveTa g

Network Receiver

Figure 3 Receiver