User's Manual

Configuring the NIU
© 2001, AXCESS Inc. 750.001.004 R0033 45
Step 14:
To ensure that no other network IP address assignment
protocols – BOOTP, DHCP or RARP – reassign the IP
address, type the following commands at the prompt:
Local_1> Change DHCP disable
Local_1> Change DHCP disableLocal_1> Change DHCP disable
Local_1> Change DHCP disable
Local_1> Change BOOTP disable
Local_1> Change BOOTP disableLocal_1> Change BOOTP disable
Local_1> Change BOOTP disable
Local_1> Change RARP disable
Local_1> Change RARP disableLocal_1> Change RARP disable
Local_1> Change RARP disable
Step 14:
At the
Local_1>
Local_1>Local_1>
Local_1>
prompt, type
show server
show servershow server
show server
. The
terminal will display the IP information that you have
provided. Ensure that it is correct.
Setting up the Serial Port
The serial port on the NIU should be configured so that it can
communicate with the Receiver. To properly configure the serial port,
type the following commands at the
Local_1>
prompt:
Command Description
Change modem control enable
Change modem control enableChange modem control enable
Change modem control enable
Allows the NIU to monitor for a
valid serial connection
Change flow control none
Change flow control noneChange flow control none
Change flow control none
Direct serial port not to use flow
control
Change break none
Change break noneChange break none
Change break none
This command tells the NIU to
ignore the Break key. The
Break key can allow a person to
leave an active session and
return without disconnecting.
Change serial delay 0
Change serial delay 0Change serial delay 0
Change serial delay 0
Changes the amount of time the
NIU will allow characters to
accumulate before sending
them out. Set the delay to 0.
Change access remote
Change access remoteChange access remote
Change access remote
Programs the NIU to accept
network connections.
Change verify disable
Change verify disableChange verify disable
Change verify disable
Controls informational
messages whenever a session
is connected, disconnected or
switched.
Change silentboot enable
Change silentboot enableChange silentboot enable
Change silentboot enable
Prevents the NIU from sending
status messages upon bootup.
Change speed 9600
Change speed 9600Change speed 9600
Change speed 9600
Sets the baud rate to 9600.
The
Show Port
Show PortShow Port
Show Port
command provides information on the serial port
settings.
IMPORTANT!
Once you set the speed, you MUST disconnect from
HyperTerminal and restart the NIU for changes to take effect.