User's Manual

Tags
© 2001, AXCESS Inc. 750.001.004 R0033 71
Step 5:
Carefully position the Tag onto the marked area of the
asset, applying pressure for the time specified in the
instructions.
Mounting a Tamper Tag
Tamper Tags have double-sided tape already applied. Be very
careful when permanently mounting the Tag. Moving the Tamper Tag
once it has been mounted will cause the Tag to enter alarm mode.
Step 1:
Remove the protective tape covering the adhesive on the
back of the Tamper Tag.
Step 2:
Press the Tag firmly to the asset.
Mounting Tags to Vehicles
Required Materials
• LED Tag
• Mounting materials – Velcro tape, double-sided tape, Mylar
enclosure
• Washable marker or pencil
Mounting locations
The first choice for mounting a Tag in a vehicle is on the upper left or
upper right side of the back window. Tags should be mounted on the
side that is closest to the receive antenna. It should not be mounted
on defroster wires. The Tag should be mounted at least 2.5 inches
away from top and sides.
Other mounting places include the upper right or left corner of the
windshield, hanging off the rear view mirror, and above either the
right or the left visor.
Testing for the Best Tag Location
This test is primarily for Tags that need to be mounted in the front
windshield area. This test may not be necessary for back window
mounting.
Step 1:
With the car out of range of the Road Loop Antenna, sit in
the car and hold LED test tag five inches from the top and
the side on the window.
Step 2:
Start the car -- while watching the LED to see if it lights.
(Note: this may occur in some vehicles due to alternator
noise.)
Step 3:
If the Tag turns on, move the tag up/right ½ inch and
repeat test until the Tag no longer turns on.