User`s manual

Installing under OS/400
132 AX3000 - User's Manual
These parameters are:
- Server: the server to which the AX3000 opens a printer connection
(press <space> to get a list of available servers).
This parameter must be entered.
- Enhanced Parameters: access to a group of parameters. The default
values of these parameters are suitable for most of the use. See next
sub-chapter.
- Printer Name (DEVNAME): printer device name.
This parameter must be entered
- Queue for Writer Messages (MSGQNAME): message queue name to
which the printer messages will be sent.
Default value: QSYSOPR
- MSGQNAME Library (MSGQLIB): associate message queue library.
Default value: *LIBL
- Font Identifier (FONT): font number (3, 4 or 5 digits).
Default value: 011
- Host Print Transform (TRANSFORM): this parameter is not available.
its value is always 'yes'.
- Manufacturer Type and Model (MFRTYPMDL): enter the printer driver
name (ex: *NONE, *HP4, *NECP2...).
Default value: *NONE
- Paper Source 1 (PPRSRC1): selected through list.
Default value: *MFRTYPMDL
- Paper Source 2 (PPRSRC2): selected through list.
Default value: *NONE
- Envelope hopper (ENVELOPE): describes the paper source 3 (selection
through list).
Default value: *NONE
- ASCII 899 support (ASCII899): specifies if the code page ASCII 899 is
supported by the printer.
Default value: *NO
- WSCST name (WSCSTNAME): qualified name of the customising
object.
- WSCST library (WSCSTLIB): associated library.
Note: if the auxiliary port used for printing is a serial port, set the 'Printer'
operating mode and set the associated parameters (baud rate, handshake, etc).