User`s manual

Remote Administration
AX3000 - User's Manual 213
AX3000 must already have been set
10.3.1 - AX3000 Remote Set-Up
To set-up an AX3000 remotely, use the 'setup_send' command. Example for
Unix/Linux:
# rsh axname setup_send password < conf_file
Notes:
- The next chapter explains how to create the configuration file conf_file,
either using a text editor or using the 'setup_get' command on an
existing terminal. Appendix A.5 contains a detailed description of the
configuration file.
- password: specify the password if the set-up is password-protected.
The message 'Store set-up in progress...' is displayed on the
operator’s console while the remote command is processing. If a connection
problem occurs, a time-out error message is displayed.
When the configuration has been successfully completed, the message 'OK,
set-up updated' is displayed on the operator’s console. If other messages
are displayed, refer to Chapter 10.3.3.
The AX3000 must read this new set-up before it will take effect. This can be
achieved either by power-cycling the AX3000 or by the following 'ax_reboot'
command. Example for Unix/Linux:
# rsh axname ax_reboot password
Note about password: specify the password if the set-up is password-
protected.
The message 'Reboot in progress...' is then displayed on the operator’s
console, the AX3000 is reset and the new set-up is implemented. If a
connection problem occurs, a time-out error message is displayed.
10.3.2 - Obtaining a Configuration
To obtain the configuration from an existing AX3000 terminal, use the