User`s manual

Initial Power-On
AX3000 - User's Manual 21
Method 3:
If "axrmserv" cannot be resolved, as a final attempt the terminal assumes
AxRM resides on the same PC as the DHCP server.
Method 4:
Only used when the location (IP address or name) and the TCP port of
the AxRM machine are specified within the AX3000 Set-Up. See Chapter
3.7.2.
The IP address of the AxRM server and the location method used is shown on
the status line:
Auto-Conf. / DHCP: aaa.bbb.ccc.ddd / AxRM (1): www.xxx.yyy.zzz:nnnn.......
The terminal sends an 'auto-configuration' request to AxRM every 5 seconds. If
no response is received after 10 attempts the terminal starts the mechanism
again, i.e. from stage 1.
This loop stops when either AxRM responds or if a user presses any key on the
keyboard, causing the normal interactive quick setup to run.
2.2.4 - Stage 4: Receiving the firmware download
A dialog box on the terminal screen provides the status. From this stage the
mechanism cannot be aborted.
Note that firmware downloading may not have been specified by AxRM, in
which case the procedure passes directly to stage 5.