User`s guide

Downloading Firmware
________________________________________________________________
114 TCP/IP AXEL Platine Terminal
b) The AX3000 and the tftp host belong to the same network
.default:\
:hn:\
:df=/etc/bootpd.dump:\
:ht=ethernet:\
:sa=192.168.1.252
:to=auto:
axel1:\
:tc=.default:\
:ha=00.A0.34.00.00.01:\
:ip=192.168.1.242:\
:bf=/tmp/axel:
IMPORTANT: if a problem occurred during a previous download operation
(whatever method was used), the firmware of the target AX3000 may have
been erased. To restore valid firmware, the bootp+tftp protocol will
automatically be run when this target AX3000 is turned on.
11.3.1 - Remote Administration
The
rcmd
command syntax is as follows:
# rcmd axname ax_download file tftpIP routeIP <CR>
-
axname
: AX3000 name listed in
/etc/hosts
,
-
ax_download
: keyword for firmware downloading,
Example:
# rcmd ax3001 ax_download <CR>
The following error message can be displayed (on the operator’s console):
-
ERR 105: invalid rcmd command
: incorrect keyword (check the
syntax).
Note: other error messages can also be displayed (connection time-out for
example). For explanations refer to UNIX manuals.