User`s manual

Installing under OS/400
TCP/IP AX3000 User's Manual 105
- Paper Source 1 (PPRSRC1): selected through list.
Default value: *MFRTYPMDL
- Paper Source 2 (PPRSRC2): selected through list.
Default value: *NONE
- Envelope hopper (ENVELOPE): describes the paper source 3 (selection
through list).
Default value: *NONE
- ASCII 899 support (ASCII899): specifies if the code page ASCII 899 is
supported by the printer.
Default value: *NO
- WSCST name (WSCSTNAME): qualified name of the customising
object.
- WSCST library (WSCSTLIB): associated library.
Note: if the auxiliary port used for printing is a serial port, set the 'Printer'
operating mode and set the associated parameters (baud rate, handshake, etc).
6.3.2 - Using the Printer
The Prt5250 service is a client service. This means that each Prt5250 auxiliary
port opens a connection to the AS/400 when the AX3000 is powered-on. From
the AS/400, a printer is available once the associated Prt5250 connection is
established.
A printer handled through the Prt5250 service is seen as a standard spooled
OS/400 printer and is managed through standard system commands:
===> GO PRINTER
6.3.3 - In Event of Problems
Nothing is printed: this is a quick test to check the hardware (AX3000
parallel/serial port, cable and printer):
- Disconnect the network cable
- Set the "Associated Service" from LPD or Prt5250 to ‘None’ for the port
being tested. Set default printer in [Configuration]→[Terminal]→
[General] to the port to be tested.
- Save changes, power cycle and enter set-up.
- Press <Print Scrn> The set-up screen should be printed.