User`s manual

Installing under OS/400
110 TCP/IP AX3000 User's Manual
Parameters of the RUNRMTCMD command:
- AX_DOWNLOAD : command for firmware downloading,
- password : specify the password if the set-up is password-
protected,
- /axfirm/ax3000 : path and name of the firmware file,
- 192.168.1.180 : AS/400 IP address,
- 192.168.1.241 : AX3000 IP address.
Messages are displayed on the target AX3000 (See Chapter 11.4).
6.4.6 - Editing AX3000 Statistics
Some AX3000 statistics can be obtained by invoking the following command:
===> RUNRMTCMD CMD(AX_GETSTAT) RMTLOCNAME('192.168.1.241' *IP)
Where:
- AX_GETSTAT : command for getting statistics,
- 192.168.1.241 : AX3000 IP address.
6.5 - FURTHER OPTIONS
6.5.1 - Turning-Off the AX3000
A careful check should be made before turning off the TCP/IP AX3000 (an
operating system cannot detect a TCP/IP device being turned-off).
To allow graceful terminal shutdown use the <Ctrl><Alt><Del> keystroke
combination.
6.5.2 - Reconnection Problem
If an AX3000 5250 session is set with a specific DEVNAME, problems can
occur if it is not cleanly shutdown before being switched off (see Chapter 6.4.1)
When a TCP/IP device is switched off (without closing current telnet session),
the operating system (OS/400) cannot detect this and the OS/400 will refuse