User`s manual

Remote Set-Up
TCP/IP AX3000 User's Manual 157
ERR 102: bad header label protocol version.
Command: setup_send
Cause: the protocol version (included in the header label) cannot be
processed by the current AX3000 firmware.
Consequence: the AX3000 set-up is not modified.
Solution: use a configuration file with a compatible protocol.
ERR 103: trailer label not found. Default factory set-up reloaded
Command: setup_send
Cause: the trailer label (END_AX_SETUP) is not found. (Either this
label is not included in the configuration file or the
connection failed).
Consequence: the default factory set-up is reloaded (to replace the
inconsistent configuration caused by the missing trailer
label).
Solution: add this label to the end of file and run the command again.
ERR 104: Can not get complete set-up (rcmd command aborted).
Command: setup_get
Cause: a network problem has occurred or the command has been
killed or aborted.
Consequence: the set-up obtained by the command is invalid (the trailer
label is missing).
Solution: run the command again.
ERR 105: invalid rcmd command.
Command: ---
Cause: the keyword is unknown.
Consequence: no effect.
Solution: use the correct keyword (setup_send, setup_get or
ax_reboot).