User`s manual

Appendix
TCP/IP AX3000 User's Manual 209
- parameters referring to non-valid sessions are commented out.
- the standard colouring mode parameters are commented out if the
s%_color_mode parameter is set to no or to enhanced.
- the enhanced colouring mode parameters are commented out if the
s%_color_mode parameter is set to no or to yes (standard).
- user-defined keys that are set to their default values (e.g. in
s%_predefined_setup) are commented out.
- the RDP password parameter (s%_rdp_password) is empty and is
commented out.
- the 5250 password parameter (s%_associate_password) is
empty and is commented out.
End of File
The configuration file must be ended with the following trailer label:
END_AX_SETUP
If this trailer label is missing, from the configuration file used to set-up an
AX3000, the fatal error message ERR 103 will be issued in response to the
rsh command and the default factory set-up will be reloaded.
A.7 - SETTING THE IP ADDRESS BY A PING COMMAND
A new feature with version ‘e’ firmware enables the system manager to
remotely assign an initial IP address to a brand new terminal, or remotely
change an existing IP address.
The procedure is to manually modify the ARP table of your computer (Unix,
Linux, Windows...). An ARP table entry is composed of IP addresses and
Ethernet MAC address". The command below associates an arbitrary IP
address to the terminal’s hard coded MAC address. The MAC address is
printed on the base of each terminal. With its updated ARP table your computer
is able to access the AX3000.To set the new IP address the terminal must be
pinged twice.
Using under Unix/Linux: