User`s manual

Appendix
TCP/IP AX3000 User's Manual 211
ax_reboot Rebooting the AX3000.
Example: rsh ax3000 ax_reboot [password]
More information: chapter 10.2
ax_sinit Resetting an AX3000 resource (screen session or aux. port)
Example: rsh ax3000 ax_sinit [password] sess1
setup_get Requesting the AX3000 Set-Up.
Example: rsh ax3000 setup_get > file
More information: chapter 10.3
setup_send Setting-up the AX3000 through a text file.
Example: rsh ax3000 setup_send [password] < file
More information: chapter 10.2
ax_download Requesting an AX3000 firmware downloading.
Example: rsh ax3000 ax_download [password] 192.1.1.1 file
More information: chapter 10
ax_version Requesting the AX3000 firmware revision.
Example: rsh ax3000 ax_version
ax_getstat Requesting the AX3000 statistics.
Example: rsh ax3000 ax_getstat
More information: chapter 9.3
Note: these commands are also available with uppercase characters
(ax_version and AX_VERSION are the same command).
A.9 - SELECTING TCP/IP OR SERIAL MODE
Two operating modes are offered by the TCP/IP AX3000:
- TCP/IP (default mode): direct connection to the Ethernet TCP/IP network
by using the network connector (RJ45 or BNC).
- Serial: asynchronous connection (RS-232) given by the AUX1 port.
The operating mode selection is done through the AX3000 interactive set-up.
A.9.1 - Serial Mode
Description of the procedure to reconfigure the AX3000 to enable serial
connection.