User`s manual

Appendix
212 TCP/IP AX3000 User's Manual
a) Enabling the Serial Mode
Enter the AX3000 Set-Up (<Ctrl><Alt><Esc>) and select the [Configuration]→
[Advanced]→[Operating Mode] menu. The displayed dialog box specifies the
current operating mode (TCP/IP) and gives the choice to 'keep this mode' or to
select the 'serial' mode.
Select the 'serial' mode. Note the displayed information box that informs you to
power-cycle the AX3000 for changes to take effect.
b) Quick Set-Up
The following parameters are needed by the serial mode quick set-up:
- Keyboard: keyboard nationality,
- Configuration: emulation,
- Speed: from 300 to 115200 bauds,
- Handshake: DTR, XON/XOFF, etc.
The quick set-up is automatically called after the serial mode is set. The quick
set-up can also be called through the interactive set-up.
c) Interactive Set-Up
The [configuration] menu offers the following commands:
- Quick Set-Up: see above
- Terminal: terminal characteristics (keyboard and monitors parameters,
emulation, colouring mode, etc.)
- Main Port (DB25): speed, handshake, etc.
- Auxiliary Port (RJ45): port mode, speed, handshake, etc.
The [Download] menu allows AX3000 firmware to be downloaded through the
network connector (bootp and tftp protocols).
Note: the 'remote set-up' feature is not available with the AX3000 serial mode.
d) Operation
When the serial mode is set, the TCP/IP AX3000 acts as the AX3000 model
40B.