User`s manual

Appendix
TCP/IP AX3000 User's Manual 213
For more information (Unix settings, multi-screen parameters, etc.), please refer
the AX3000 model 40B literature.
A.9.2 - TCP/IP Mode
Description of the procedure to configure the AX3000 terminal for TCP/IP
Ethernet mode from serial mode.
a) Enabling the TCP/IP Mode
Enter the AX3000 Set-Up (<Ctrl><Alt><Esc>) and select the [Configuration]→
[Advanced]→[Operating Mode] menu. The displayed dialog box specifies the
current operating mode (serial) and gives the choice to 'keep this mode' or to
select the 'TCP/IP' mode.
Select the 'TCP/IP' mode. Note the displayed information box that informs you
to power-cycle the AX3000 for changes to take effect.
b) Setting-Up and Operation
Refer to the previous chapters in this document.
A.10 - GOING FURTHER...
This chapter describes special AX3000 operating parameters. Usually the
default values are suitable.
All these parameters are located in a specific dialog box in menu
[Configuration]→[Advanced]→[Tunings]. This dialog box varies depending
on the AX3000 model.