User`s manual

Appendix
TCP/IP AX3000 User's Manual 219
The AX3000 will not transmit data for printing if the printer handles only the
"Busy" signal,
This parameter determines whether the "Select-In" and/or "Paper Empty"
signals will be selected in addition to the "Busy" signal (which is always used).
Note: the signal modification takes immediately effect.
A.10.13 - The 'Operating Mode' Parameter
This parameter is common to all TCP/IP AX3000 models.
Data is usually sent to the parallel port through a method based on 'interrupts'.
This makes efficient use of the AX3000 CPU.
In event of problems (no printing or a very slow printing), it is possible to change
this parallel port management and to send data by a 'polling' method. To enable
this method, set the "Operating Mode" parameter to "Standard".
Note: the parallel port management modification takes immediately effect.
A.11 - DEFAULT FACTORY SET-UP AND QUICK SET-UP
Quick Set-Up allows an AX3000 to be rapidly updated for immediate use.
Two steps can be distinguished during the terminal reset:
- AX3000 default settings are loaded,
- the AX3000 settings are updated with the quick set-up information.
In the list below the parameters shown in bold type are issued from the quick
set-up.