User Manual

AXELL CSR 3604-3304 UHF REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
8 DOC PN 3633B-UM Rev. 2.1 © Axell Wireless Ltd
2.1.3 Installation Criteria
Installation requirements:
 Select a location for the Donor antenna and verify that there is enough signal strength at
that location.
 Install the Donor Antenna at the designated height.
 The antenna should point to the direction of the base station for maximum input power.
 Verify that the antenna is in the base stations line of sight (raise the antenna if needed).
 Install the donor antenna at a higher level (i.e. floor) than the mobile antenna.
2.2 Service Antenna Requirements
WARNING!!!
a. The installer is held accountable for implementing the rules required for deployment.
b. Good engineering practice must be used to avoid interference.
c. Output power should be reduced to solve any IMD interference issues”
The Service antenna type depends on the design of the indoors DAS.
2.2.1 Required Antenna Information
The following antenna requirements, specifications and site considerations should be met:
 Type of installation – indoor DAS/Radiating Cable
 Service area type and size
 Antenna type and characteristics
 Height
 Length and type of coaxial cable required for connecting the antenna to the Repeater
and the attenuation.
2.2.2 Indoor Installations
2.2.2.1 Recommended Antennas
The following describes the requirements for an omni-directional mobile used for indoor
applications.
Specifications:
 One or a combination of the following antennas can be used: Ceiling Mount Patch
antenna, Wall Mount Patch antenna, Corner Reflector.
 Choose an antenna with high side lobe attenuation which enables maximum isolation
from the service/ mobile antenna.