User Manual

AXELL CSR 3604-3304 UHF REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
16 DOC PN 3633B-UM Rev. 2.1 © Axell Wireless Ltd
4.5.2 Planning the Repeater Location and Drilling
1. Mark out on the chosen wall the fixing centres of the repeater and the location of the
brackets.
2. Mark and drill the wall with the correct size masonry bit as specified by the fixing
manufacturer.
WARNING: It is good practice to wear goggles to protect your eyes from
flying debris when using power tools.
3. Hold the drill bit against the mark and begin drilling slowly so that the bit does not
wander from the position. The wall should be drilled to a depth which is sufficient to
accommodate the full length of the fixing.
4. Insert the fixings so that the top of the sleeve/anchor section is level with the wall
surface.
5. Gently tighten the bolt by hand so that the anchor section of the fixing expands and grips
the inside of the hole.
Figure 4-3. Inserting Fixing and Tightening
6. As the bolt pulls its way in, the sides of the anchor section are forced outwards, gripping
the surrounding surface.
Figure 4-4 Anchor Sides Pushed Outwards
7. Once all four fixings are in place, carefully withdraw the four bolts.
Figure 4-5. Withdraw Bolts.