User Manual

AXELL D-CSR 3302 US VHF REPEATER

PRODUCT DESCRIPTION AND USER’S MANUAL

6.3 CSR Channel Configuration

The initial setup procedure consists of defining the required VHF channels. Up to eight

channels can be defined, where each channel is defined according to the following

parameters:

 UL center frequency and DL center frequency

 Type of channel according to usage (High Selectivity or Low Delay)

 Attenuation

 Power level

To configure channel RF parameters

1. Access the Home screen (displayed by default).

A partial image showing only the channel definitions area is illustrated below.

2. Define the Downlink and the Uplink parameters for each required channel:

 Set the Centre frequency.

 Set the type of Filter to Low Delay or High Selectivity according to site

requirements.

 Set the Power Level according to the following options:

 Max – maximum power available according to the number of active channels.

 Max-1 to Max-9 – from 1 to 9 dBm less than the maximum power according

to the number of active channels.

 OFF – no power is transmitted on corresponding UL or DL channel.

NOTE: Be sure to disable inactive channels by setting the Power Level to OFF.

Downlink channel

definitions

Uplink channel

definitions