User Manual

AXELL 3604 A284 SERIES UHF REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
12 DOC PN 3604 A284 Series-UM © Axell Wireless Ltd
4 Physical Installation
4.1 Overview of the Installation Procedure
Note the following:
 The Donor and Mobile antennas can be positioned and installed (without connection
to the Repeater) at any time either before or after mounting and grounding the
Repeater.
 It is important to perform the installation procedure according to the order described
below..
System installation phases:
1. Determine an appropriate location for the system according to the requirements
described in section 3.3.
2. Unpack the Repeater Kit
3. Assemble the brackets and mount the CSR Repeater on the (concrete or brick) wall (see
4.4.).
4. For models supporting a modem:
Insert the SIM card (requires opening repeater door).
Connect the modem antenna (external port)
5. Ground the Repeater (see 4.6)
6. If you have not already done so, position and install the Base and Mobile antennas in
the relevant locations (see chapter 2).
7. Before powering up the Repeater:
Verify isolation between the donor and mobile antennas.
Verify link between BTS and Base Repeater.
Connect the Donor and Service antennas to the Repeater.
8. Power-up the Repeater.
WARNING! Be sure to perform the power supply connection last,
otherwise damage may be caused to the system!
9. Optional - Connect the external alarms. This can be done at any time, before or after
powering up the Repeater.
10. Initial system setup. See Chapter 6