User's Manual

44
Please note: You will need to remove the motion sensor battery cover in order to register
your sensor. You must be in the programming mode to perform this function.
Add Sensor in Zone 1
Func Key11FuncKey
Zone 1 LED will light then
press the sensor button.
Add Sensor in Zone 2
Func Key12FuncKey
Zone 2 LED will light then
press the sensor button.
Add Sensor in Zone 3
Func Key13FuncKey
Zone 3 LED will light then
press the sensor button.
Add Sensor in Zone 4
Func Key14FuncKey
Zone 4 LED will light then
press the sensor button.
Please note:You need to press the button of the desired sensor within 30 seconds to
registerit correctly. If the sensor has not been registered properly there will be a long
beep and all 4 Zone LEDs will blink red 3 times. If the sensor has been registered
properly then you will hear 2 beeps and all 4 Zone LEDs will blink green 1 time.
To add additional sensors in your desired zone please repeat the above instructions.