User`s guide
3: Advanced Programming • 25
Version 1.2 July 2010
The  configuration  and  operation of  the  IC.10X  is 
quite  straight-forward  and  if  you  have  understood  our 
previous section on the IC.20, you will have no problem 
extending that knowledge to the IC.10X. 
IP Address
The IC.10X has an ID button on the rear panel. This 
switch is used in conjunction with Axia iProbe software 
or the  BootP utility  as described  in detail  at the  begin-
ning of this chapter.
The  IP  address  may  also be  changed  from  the  Sys-
tem page of the configuration as shown in Figure 3-14.  
Remember that if  you change the  IP  address, you will 
lose the connection to your web browser and it will be 
necessary to “point” your browser at the new IP address 
to restore the connection.
 Web Page Conguration
The web pages of the IC.10X will look familiar since 
it is simply an extension of the IC.20 channel capacity.
Home Page
The IC.10X has only two options on the home page 
as shown in Figure 3-12. 
•  Intercom Expansion Configuration
•  System Parameters
Figure 3-12: IC.10X Home Page
Intercom Expansion Conguration
This page simply allows you to specify the Label of 
the IC.20 master to which you are associating the expan-
sion and which bank of 10 stations you are assigning to 
this  module. You  may  have  more  than  one  IC.10X  as-
sociated with an IC.20  master  - just be sure to specify 
different channel ranges for each expansion chassis.
System Page
The  configuration  contains  the  familiar  IP  settings, 
password and  Firmware Version  sections that  are  fully 
described  earlier  in  this  chapter. The IP  address,  other 
network settings, syslog server, password, firmware up-
dates  are  all  handled  in  a  manner  identical  to  that  de-
scribed previously for the System Page of the IC.20 main 
station. 
It is highly recommended that any IC.10X expander 
chassis  should  run  the  same  version of  software as  its 
associated main chassis. 
Figure 3-14: IC.10X - System Conguration Page
IC.20 with IC.10X
When you are using an IC.20 chassis with an IC.10X 
expander,  you  will  notice  a  change  to  the  Key Assign 
Figure 3-13: IC.10X Expansion Conguration










