User`s guide

4: Setup and Conguration • 22
©2014 Axia Audio - Rev.1.3.8
Intercom Conguration Page
Figure 4-13
The conguration page denes how the station will
behave and how it interacts with other stations.
External Sources Page
Figure 4-14
External sources can be used in different ways such
as Axia console source insert, constant monitor source,
3rd party intercoms, IFB to a source (route change), a
source for monitoring, push to talk radios, and likely
more.
Key Assignment Page
Figure 4-15
Key assignment page is where the each channel is
dened with a source and if Talk, Listen, or latch is
enabled. The options will vary based on device. An 10
channel intercom station with lmcap buttons is shown.
A 20 station OLED would be slightly different and an
IC 20 with expansion IC10x would again be slightly dif-
ferent.
Livewire GPIO Page
Figure 4-16
Intercom stations will have different amount of
ports shown on the GPIO page. The Aux1-8 reect vir-
tual ports as mentioned in the GPIO section. The Main
GPIO port is where the standard Intercom stations logic
is located. The Hardware port (if available) represents a
physical port and is assigned a function.