User`s guide

4: Setup and Conguration • 24

This will commit Bank 1 to Bank 0 and Bank 1 would

be available for a new upload.

Factory Reset (rackmount + Desktop)

Rackmounts and Desktop models provide an option

to reset back to factory default. This is done by remov-

ing power from the unit. Locate the ID button on the

back panel. Press and hold the button while power is ap-

plied to the unit. Keep pressing the button for about 10

seconds. OLED models will provide a reset count down

time on the display. Filmcap models will ash the but-

tons several times and then stop.

Display Tests (rackmount + Desktop)

The intercom stations have a test mode that tests the

displays, buttons and provides an option to adjust the

brightness. With power applied, press and hold the ID

button for 10 seconds.

When in test mode, the four status LEDs (NET,

SYNC, Livewire, Master) will scroll in sequence. OLED

displays will show TEST. Pressing a button will illu-

minate the LED associated with the button. Pressing a

button on lmcap models will engage the LED for the

button. Each additional press will change the color of

the light (Green, Red, Yellow, none). Rotatingte encod-

ers on OLED models will display numerical values on

the OLED. For lmcap models, the buttons should be il-

luminated and rotating the knob will change the bright-

ness of the buttons.

Exit test mode is done so by pressing the ID button

once on the rear panel.

Console modules can be tested by accessing the un-

derside of the module and rotating a 16 position switch

to the F position.