Owner manual

AX24250 AE-1 Forward/Reverse ESC Instructions
AX24250-I001
Input Voltage
Size
Weight
Motor
On-Resistance-Forward FET
On-Resistance-Reverse FET
Rated/Peak Current-Forward
Rated/Peak Current-Reverse
Braking Current
BEC Voltage/A
PWM Frequency
5~10 Cell-2VDC/Cell
34.8 x 33.5 x 30mm
53g
15T or greater
0.0025Ω
0.005Ω
60A / 150A
35A / 75A
150 A
DC 5V / 1A
1 K Hertz
Specifications:
CAUTION
Setup:
• Mount the ESC in an area that is well ventilated and isolated from vibration and shock.
• Connect the ESC wires to the motor.
• Plug the receiver wire into the throttle channel on the receiver.
• Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at zero
• Switch on the power of the ESC, make sure your radio is on
• The ESC will emit 3 beeps confirming the ESC is ready to work
• Apply throttle to make sure the motor is going the direction you wanted. To reverse the direction of the motor
switch the wires going to the motor. Do not reverse the battery wire connections! Reversing the battery
polarity will permanently damage the ESC.
Connect the battery pack just before driving and disconnect it immediately after.
Always make sure you are connecting the ESC to a proper power source that has the correct voltage & polarity.
Incorrect voltages or reversed polarity will damage the ESC.
Once the battery pack is connected, handle the model with extreme care, make sure you are clear of all rotating parts.
+
+
Orange
Blue
Motor
Black
Red
-
-
Battery