User Manual

Adjust to the appropriate range.

Suitable battery size.

5.75” x 1.2” (147mm x 32mm)

5.44” x .94” (138mm x 24mm)

Battery Tray

X31373

M2.6x8mm

AE-5 Forward/Reverse ESC w/ Drag Brake

Mount the ESC in an area that is well ventilated and isolated from vibration and shock.

Connect the ESC motor wires to the motor red-red & black-black.

Plug the receiver with into the throttle channel on the receiver. The black negative wire should be

towards the outside of the receiver.

Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at

zero.

Connect the battery to the ESC, this will turn on the ESC.

Test forward and reverse control using the transmitter.

To calibrate the ESC, make sure the transmitter is on and the throttle control is at neutral.

Connect the battery to the ESC and wait 3 seconds to let the ESC initiate a self-test and automatic

throttle calibration.

When the ESC is ready to run a long beep sound will be emitted from the motor.

Always disconnect the battery when the vehicle is not in use.

AX31373

AX31590