TTX300 Transmitter Manual

ManualsBrandsAxial ManualsHobbySCX10 II 1969 Chevrolet Blazer RTR 4WD Rock Crawler

TTX300

™

2.4GHZ RADIO CONTROL SYSTEM

INSTRUCTION MANUAL

Thank you for making the Tactic

TTX300 2.4GHz SLT system

your choice for radio control!

This system uses modern 2.4GHz Spread

Spectrum technology – an innovation that

allows for automatic channel selection and

interference-free control of R/C models.

For safe operation and best results, it’s strongly

recommended to read this manual in its entirety

before use! Also read and understand the instructions

included with the model. Damage resulting from

misuse or modiﬁ cation will void your warranty.

FEATURES

● 2.4GHz Spread Spectrum Technology

● Ergonomic and stylish case design

● Transmitter can bind to multiple receivers

● Tiny, lightweight receiver with internal antenna

● Built-in fail-safe

● Steering and Throttle trim dials

● Steering rate adjustment

● Power LED with low battery warning indication

● Multi-function programmable 3rd channel

● Steering and throttle end point adjustments

Summary of content (12 pages)

PAGE 1
TTX300 TM 2.4GHZ RADIO CONTROL SYSTEM INSTRUCTION MANUAL ™ Thank you for making the Tactic TTX300 2.4GHz SLT system your choice for radio control! This system uses modern 2.4GHz Spread Spectrum technology – an innovation that allows for automatic channel selection and interference-free control of R/C models. For safe operation and best results, it’s strongly recommended to read this manual in its entirety before use! Also read and understand the instructions included with the model.
PAGE 2
TRANSMITTER The transmitter (Tx) requires 4 “AA” batteries. Non-rechargeable alkaline or rechargeable nickelcadmium (NiCd) or nickel-metal hydride (NiMH) cells can be used. Do not mix old and new cells, or mix non-rechargeable alkaline cells with rechargeable NiCd or NiMH cells, etc. See the SERVOS AND ACCESSORIES section at the end of this manual for optional rechargeable NiCd and NiMH batteries and chargers. Note the TTX300 transmitter does not include a charge jack for rechargeable cells.
PAGE 3
. If the receiver’s LED flashes once and then stays on, the Rx is already bound to the Tx and you can skip to the next section. Otherwise, push and hold the receiver’s “BIND” button until its LED glows red and then turns off after about one second. 4. Release the bind button. 5. If the binding is successful, the LED will flash once and then remain ON. 6. Test for proper Tx / Rx functionality by completing the next section. If it doesn’t seem the radio has bound properly, repeat steps 1-6 above.
PAGE 4
PROGRAMMING Several of the TTX300 features are adjusted electronically by entering the programming mode. To enter the programming mode, follow these steps: 1. With the transmitter turned off, turn steering wheel full right, pull the trigger to the full throttle position and turn the transmitter’s power switch to ON. The LED will flash to confirm when performed correctly. 2. Release the wheel and trigger at this time. End Point Adjustments Steering: Throttle: 1. Enter programming mode. 2.
PAGE 5
Moving the steering wheel during adjustment of CH3 will save the position. Do not move steering wheel unless position is ready to be saved. 3. Use CH3 push buttons to adjust CH3 accessory/servo to desired 2nd position. Turn steering wheel clockwise (right) to confirm position 2. The LED will flash two times to confirm position 2 has been saved. If programming for two position switch, skip to step 6. Otherwise, proceed to step 5 to program 3rd or 4th position. 4.
PAGE 6
communications from the transmitter. When the receiver regains signal it will automatically resume normal function. Range Check: The “range” or safe operating distance from the Tx to the Rx is typically as far as you can clearly see the model. Before operating the model, perform a simple range check to make sure the transmitter maintains good radio contact with the receiver within your operating area.
PAGE 7
Switch harness or ESC is connected incorrectly – check all connections and the ESC instruction manual. Rx is not binded to the Tx properly – perform binding process again. Rx antenna located too closely to engine, motor, servos or other moving mechanical parts which might be creating unwanted electrical noise – relocate the Rx inside the model or relocate the ESC. INTERFERENCE OR SERVOS GLITCHING: Out of range – operate the model more closely to the transmitter.
PAGE 8
SERVOS AND ACCESSORIES Stock # TACM0235 TACM0240 TACM0245 TACM0247 TACM0255 TACM0257 TACM0265 TACM2000 TACM2001 TACM2002 TACM2020 TACM2090 TACM2091 TACM2092 TACM2093 DTXP4704 DTXP4191 DTXP4225 DTXP4235 DTXP4245 DTXP4615 DTXC3164 DTXC3165 DTXC3166 DTXC3172 DTXC3174 Description TSX35 Standard Servo Sport TSX40 Standard Servo High Speed MG 2BB TSX45 Standard Servo High Torque MG 2BB TSX47 Standard Servo Digital High Torq MG 2BB TSX55 Standard Servo Ultra Torque MG 2BB TSX57 Standard Servo Digital Ultra Torq M
PAGE 9
DECLARATION OF CONFORMITY: Product: Tactic TTX300 2.4GHz 3-Channel Pistol Tx Rx Item number: TACJ0300 Equipment class: 1 TACTIC TTX300 TRANSMITTER AND TACTIC TR325 RECEIVER: The objects of the declaration described here are in conformity with article 3.1(a) the requirements of safety contained in the European 2006/95/EC Directive and article 3.1(b) the requirements of EMC contained in Directive 2004/108/EC and article 3.2 requirements of radio equipment in Directive 1999/5/EC.
PAGE 10
2.Les changements ou modifications de cette unité non expressément approuvés par la partie responsable de la conformité pourraient annuler l’autorité de l’utilisateur à utiliser l’équipement. IC RF Déclaration sur la radioexposition: Cet appareil est conforme avec I’exposition aux radiations IC Définies pour un environnement non contrôlé. Les utilisateurs finaux dovivent suivre les instructions de fonctionnement spécifiques pour satisfaire la conformité aux expositions RF.
PAGE 11
In the European Union, send it postpaid and insured to: Service Abteilung Revell GmbH Henschelstrasse 20-30 32257 Bünde Germany Tel: 01805-110111 (nur für Deutschland) E-mail: Hobbico-Service@Revell.de Distributed in the EU by Revell GmbH, Bünde Germany ● ● ● ● ● This product is suitable only for people of 14 years and older. This is not a toy! WARNING: CHOKING HAZARD - May contain small parts. Keep away from children under 3 years. Please retain packaging for future reference.
PAGE 12
END POINT ADJUSTMENTS FUNCTION CH1 EPA CH2 EPA DEFAULT CH3 EPA Enter Programming Mode: Wheel full clockwise (right), trigger full throttle (pull), power on Tx Turn wheel anti-clockwise. Left EPA Use CH3 buttons to adjust. Turn wheel clockwise. Right EPA Use CH3 buttons to adjust. Enter Programming Mode: Wheel full clockwise (right), trigger full throttle (pull), power on Tx Pull trigger to full throttle. Throttle EPA Use CH3 buttons to adjust. Push trigger to full brake.