AXI90060 Axial AE-5L ESC Manual

4 LED White & Red Light String

AX31480 AE-5L Forward/Reverse EAS w/ Drag Brake

Mount the ESC in an area that is well ventilated and isolated from vibration and shock.

Connect the ESC motor wires to the motor red-red & black-black.

Plug the receiver with into the throttle channel on the receiver. The black negative wire should be

towards the outside of the receiver.

Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at

zero.

Connect the battery to the ESC, this will turn on the ESC.

Test forward and reverse control using the transmitter.

To calibrate the ESC, make sure the transmitter is on and the throttle control is at neutral.

Connect the battery to the ESC and wait 3 seconds to let the ESC initiate a self-test and automatic

throttle calibration.When the ESC is ready to run a long beep sound will be emitted from the motor.

Always disconnect the battery when the vehicle is not in use.

Connecting the 2 LED wires to the ESC. The wires should color match.

Front

Rear

4 LED white light string (Optional)

AX31481

AE-5L LED Light Set

AX31480

AE-5L ESC w/ LED Light Ports

Receiver Servo

White LED's Red LED's

Red/Black Only

White/Black Only

AX31480-I001

PAGE 1
AE-5L Forward/Reverse EAS w/ Drag Brake AX31480 Mount the ESC in an area that is well ventilated and isolated from vibration and shock. Connect the ESC motor wires to the motor red-red & black-black. Plug the receiver with into the throttle channel on the receiver. The black negative wire should be towards the outside of the receiver. Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at zero. Connect the battery to the ESC, this will turn on the ESC.