Instruction manual

A758 Owner’s Guide Chapter 6: Communiction Interface
September 1999 95
Power Connector
With RS-232C, the printer is always remotely powered. The following illustration
shows the power cable connector and pin assignments. The power cable
connector is a 3-pin mini DIN plug and is located at the rear of the printer.
3 Not Used
1 Ground
Function
Pin Numbers
Function
+24 Volt 2
Sh
e
ll - Shi
e
l
d
Cash Drawer Connector
A 6-contact modular jack (RJ11) is available to drive a cash drawer with
dedicated feedback, or up to two cash drawers without feedback. The following
illustration shows the pinouts for the cash drawer connector.
Pin 1
Pin 6
The following table shows the pinouts for the cash drawer. The connector can
support two cash drawers with a Y cable, and is located at the rear of the printer.
Pin Number Cash Drawer Connector
1Frame Ground
2 Drawer 1 Solenoid
3 Drawer 1 Status Switch
4 +24 Volts (to Solenoid +)
5 Drawer 2 Solenoid
6 Ground (Status Switch Return)
The maximum current supplied is 2.0 Amps, and the pulse width is
programmable from 50 to 300 milliseconds.