Instruction manual

A758 Owner’s Guide Chapter 7: Programming Guide
September 1999 119
Select Slip Station
ASCII
:FS
Hexadecimal
:1C
Decimal:
28
Selects the Slip Station for all functions. The receipt station is the default setting
after the printer is initialized or the Clear Printer (0x10) command is received.
Select Cut Mode and Cut Paper
ASCII
:GS V
m
GS V
m n
Hexadecimal
: 1D 56
m
1D 56
m n
Decimal:
29 86
m
29 86
m n
Value of
m
: Selects the mode as shown in the table
Value of
n
:
Determines cutting position only if
m
is 65 or 66.
M Feed and Cut Mode
0, 48 Full cut (no extra feed). Partial cut on the A758.
1, 49 Partial cut (no extra feed).
65 Feeds paper to cutting position + (
n
times vertical
motion unit), and cuts the paper completely.
66 Feeds paper to cutting position + (
n
times vertical
motion unit), and performs a partial cut.
Range of
m
:
0, 48; 1, 49
65, 66 (when used with
n
)
Range of
n
:
0 - 255
Default of
n
:
0
Default of
m
:
0
Selects a mode for cutting paper and cuts the paper. There are two formats for
this command, one requiring one parameter
m
, the other requiring two
parameters
m
and
n
. The format is indicated by the parameter
m.
Formulas:
n
times the vertical motion unit is used to determine the cutting
position to which the paper is fed.
Exceptions:
If
m
is out of the specified range, the command is ignored.