Setup guide

11
Set the 10K120 Interface Options
See the options in the section below.
• The 10K120 options can now be set by scanning the supplied bar codes.
• If the 2127 register does not have a scanner, manually enter the bar code PLU
numbers via the keyboard.
Configure and Customize the 10K120 Interface
There are 27 option and command items that can be set or controlled. See the
following table.
The normal procedures to ring up an item also apply to these configuration items.
The configuration items are zero priced, so store totals will not be altered.
Scanning a tag or entering the respective UPC item number will cause the
10K120 interface to perform the indicated action.
The first five and last two configuration items in the table below are action items
and do not set a configuration parameter. They perform the indicated action
immediately.
The remaining items set configuration parameters. They require the Save
Configuration Tag to be entered directly after entering the configuration item
tag(s).
The Save Configuration Tag applies to items 106 through 119 in the
Configuration Item Tag Table. The numbers are the last three digits of the item
PLU number.
If the save configuration tag is not used, the entered configuration parameter(s)
will be valid only until the next power cycle at which point the cable will revert
to the last saved settings.