User's Manual

Stealth Repeater

- QSG

FCC Compliance

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

--Consult the dealer or an experienced radio/TV technician for help.

FCC ID: VE4-BER2

Caution: Changes or modifications not expressly approved by the manufacturer could void the

user’s authority to operate the equipment. Only the manufacturer supplied antenna is approved

for operation with the equipment.

To comply with FCC RF exposure requirements, the device and the antenna for this device must

be installed to ensure a minimum separation distance of 20 cm or more from a person's body.

Other operating configurations should be avoided.