User's Manual

ManualsBrandsAxiometric ManualsElectronicsWM2E Water Meter

Stealth Reader

Mounting

When putting a Meter and Register in a certain location it has to be properly mounted. The mounting that will be

described in this Manuel will be Pit Mounting. There are other ways to mount compatible with the Stealth Reader,

Wall and Pole mounting.

Pit Mounting

1. Get the materials for the mounting like in the

picture to the right. (Not including Lid)

2. Take the Lid of the Pit Mount and put the

Screw Top, into the hole in the Lid having

the threaded part pointing down into the

inside of the pit.

3. To raise the antenna for better signal put the

Raiser, between the Screw Top and the Lid.

4. To Secure the Screw top onto the Lid take

the Nut and twist it onto the Screw Top until

it can't tighten anymore, but do Not over-

tighten it.

5. Now take the top of the Stealth Repeater,

the end that isn't hooked up to the register,

and put it into the Screw top. Turn it untill a

click is heard, this click means the Stealth

Reader is locked into the Screw Top.

6. Now place the register into the pit and lay the lid and check to see if it will close all the way

without putting weight on the Stealth Reader. Never let the weight of the Lid be on the Stealth

Reader, it will cause damage.

7. Pick up all trash in the area and in the pit.

8. When the Lid can close turn the bolt clockwise, so the Lid is locked.

Proper/ Improper Mounting

When mounting the Stealth Reader it can be done correctly and incorrectly. This section will help clarify

what is improper mounting and how to fix it.

Pit

The Pit Mounting is done so the Stealth Reader is sitting

correctly and the lid can close securely to seal up

properly. The picture to the right shows a improper

installation of the Stealth Reader. The Reader is sitting to

high and the lid can't close properly. To fix this problem

remove some dirt underneath the reader till the lid can

close properly without putting any weight on the Stealth

Reader. Also check to see if the Stealth Reader isn't

messed up, like the device isn't in the Screw Top properly

or anything of that nature that can cause a problem. This

problem needs to be fixed because the Stealth Reader

isn't safe with the lid not over it, it can be stolen, and or damaged. Also in the situation like in the

picture, the weight of the lid is on the Stealth Reader. This can cause internal problems as well

as damage the device itself.

1= Screw Top, 2=Nut, 3=Raiser, 4=Stealth

Reader