User's Manual

Stealth Reader

wires are connected correctly before filling pods with epoxy.

If the wires are hooked up wrong and need to go back and redo them these are the steps to fix the problem.

1. Cut off the wires where they go into the UY gel caps.

2. Repeat procedures 2-4 from the section above.

There are some registers that do not connect through wires. Instead they have screws that are next to the

indicator that shows which color it would be in the previous chart. Below are the steps to connect the wires to

that type of register.

1. Look at the chart to find out which wires go to what for that specific register.

2. Wrap the correct wire around the screw clockwise.

3. Tighten the screws while also making sure the wire stays in place. In doing this if the wires are wrapped

around the correct way, it will tighten itself when the screw is being tightened.

Splicing Techniques

This is the method to makes sure the wire connections are completely water proof.

Water Pit Splice Method using burial pods

• Fill the burial pod up to a half to two-thirds of the way

full with epoxy.

• Insert the UY connection into the burial pod so the

cables come out on either side of the pod.

• Completely fill the empty space left in the pod with

approved 2-ton epoxy.

• Tap to the Burial pod ageist a hard surface to release

any air bubbles.

• Close the burial pod by snapping is shut and allow 30

minutes of drying time.

Water Pit Splice Method for Direct Register

Connections

• Strip the wires back 4 inches.

• Cut excess wires and direct connect to meter

according to wire connections guide per register

type.

• Put remaining wires in black pod and fill with epoxy

per approved method.