User`s manual

PICO820 Series All-In-One PICO ITX Board User’s Manual
Installation of Drivers
36
 Quick Power On Self Test
This option speeds up Power on Self Test (POST) after you turn on
the system power. If set as Enabled, BIOS will shorten or skip
some check items during POST. The default setting is “Enabled”.
Enabled
Enable Quick POST
Disabled
Normal POST
 First/Second/Third Boot Device
These items let you select the 1st, 2nd, and 3rd devices that the
system will search for during its boot-up sequence. There is a wide
range of options for your selection.
 Boot Other Device
This item allows the user to enable/disable the boot device not
listed on the First/Second/Third boot devices option above. The
default setting is “Enabled”.
 Boot Up NumLock Status
Set the the Num Lock status when the system is powered on.
The default value is “On”.
 Security Option
This item allows you to limit access to the system and Setup, or just
to Setup. The default value is “Setup”.
System
If a wrong password is entered at the prompt, the system
will not boot, the access to Setup will be denied, either.
Setup
If a wrong password is entered at the prompt, the system
will boot, but the access to Setup will be denied.
NOTE To disable the security, select PASSWORD
SETTING at Main Menu and then you will be
asked to enter a password. Do not type anything,
just press <Enter> and it will disable the security.
Once the security is disabled, the system will boot
and you can enter Setup freely.
 APIC Mode
Use this item to enable or disable APIC (Advanced Programmable
Interrupt Controller) mode that provides symmetric multi-
processing (SMP) for systems.