User Manual

AXIS P3384–V
Accessing the Product
Select the power line frequency (50 Hz or 60 Hz) used at the location of the Axis product. Selecting the wrong frequency may cause
image flickeriftheproductisusedinfluorescent light environments.
When using 50 Hz, the maximum frame rate is limited to 25 fps.
Note
Power line frequency is different in different geographic regions. In the Americas, 60 Hz is usually used; most other parts of
the world use 50 Hz. Local variatio ns may apply, always check with the local authorities.
The Live View Page
The controls and layout of the Live View page may have been customized to meet specific installation requirements and user
preferences. Consequently, some of the examples and functions featured here may differ from those displayed in your own Live View
page. The following provides an overview of each available control.
Controls on the Live View Page
Click View size to scale the image down to 800 pixels wide or to full scale. Only available in MJPEG.
Click WDR on to enable WDR in intense backlight conditions; see Wide Dynamic Range on page 17. Click
Lightfinder Mode to enable this mode; see Lightfinder Mode on p age 17.
The Stream Profile drop-d own list allows you to select a customized or pre-programmed stream profile. Stream
profiles are configured under Video & Audio > Stream Profiles.SeeStream Profiles on page 16.
Click Pulse to activate the output for a defined pe riod of time, such as switching on an exte rnal light for 20 seconds .
Click the Active/Inactive buttons to manually start and stop a connected device — e.
g. switch an external light
on and off.
The Manual Trigger button is used to trigger an a ction rule from the Live View page; see . E nable this button
from Live View Config > Action Buttons.
Click Snapshot to save a snapshot of the video image. Right-click the video image to save it in JPEG format on your
computer. This button is p rimarily intended for use when the AXIS Media Control viewer toolbar is not available.
Enable this button from Live View Config > Action Buttons.
The Audio clip drop-down list allows you to play an audio clip from the Live View page. Select the audio
clip and click the Play button.
Activate the product’s fan with this button. Enable this button from Live View Config > Action Buttons. The Fan
button is activated automatically. Press this button to activate it manually.
Activate or de-activate IR illumination from Setup > Video & Audio > Camera Settings.Movetheslidertoincrease
or decrease the intensity of the LEDs. Enable this button from Live View Config > Action Buttons.
8