User Guide
Table Of Contents
- An Introduction to the AXIS 2420
- Physical Description
- Checking The Hardware Inventory
- Installing on a Network
- Installing via a Modem
- Focusing Your Camera
- Configuring Your Camera
- The Factory Default Settings
- Choosing Your Application
- The AXIS 2191 Audio Module
- Appendix A - Troubleshooting
- Appendix B - Other IP Setup Methods
- Appendix C - Lenses and Advanced Focusing
- Appendix D - Customizing Your Camera
- Appendix E - Updating the Firmware
- Appendix F - The Unit Connectors
- Appendix G - High-Speed Services
- Appendix H - Technical Specifications
- Physische Beschreibung
- Überprüfen des Lieferumfangs
- Installieren in einem Netzwerk
- Anschließen an ein Modem
- Scharfeinstellung der Kamera
- Werkseitige Standardeinstellungen
- Description du Materiel
- Vérification de la liste du matériel
- Installation sur un réseau
- Installation par l’intermédiaire d’un modem
- Mise au point de votre caméra
- Restauration des paramètres d’usine par défaut
- Descripción física
- Comprobar el inventario de hardware
- Instalación de la cámara a una red
- Instalación de la cámara a un módem
- Enfocando la cámara
- Incluir los parámetros por defecto
- Index
Configuring Your Camera AXIS 2420 User’s Manual
26
Modem
The Modem page allows you to set your specific modem type and configure it, using the
following parameters:
• Disable incoming calls - use this only if you will not need to dial-in to the AXIS 2420.
• Modem Type - set the brand of modem and provide a specific Initstring, if required.
• Communication Settings - advanced settings for your modem. Please see the documentation
for your modem.
• Callback - use this to get your modem to return your call. The number of ring signals to wait
before callback and the number of seconds to wait before disconnecting can both be set.
ISP
This page provides the fields for entering the information specific to your own ISP. If your
own ISP is not listed, use the Generic setting. The settings available are; the number you
dial to your ISP, your user name and password, the connection type and the re-dialing
properties. You can save on phone bills by setting the connection type to Closes After or
Optimized. See the on-line help for more information.
Using Pan-Tilt-Zoom Devices
There is a wide range of Pan-Tilt-Zoom (PTZ) devices available on the market today. Some
of these can be used with your AXIS 2420 to provide a simple means of remotely aiming
and controlling your camera. A PTZ device connects directly to the AXIS 2420 via the
RS-232 port or RS-485/422 port on the back panel of the camera. Both ports support the
use of these devices, but only one port at a time can be used for the purpose.
Apart from the COM settings shown by default for the COM ports, selecting External
Device for the port will also reveal a section called Pan Tilt Settings. The drop-down list
allows you to select the driver for your PTZ device. The devices in the list are the ones
currently supported by the AXIS 2420. For the latest information concerning supported
PTZ drivers, please see the Axis Web at www.axis.com.