User's Manual

AXIS P1346–E Network Camera

System Options

The following traps are available:

•Coldstart

•Warmstart

•Linkup

• Authentication failed

SNMP v3 provides encryption and secure passwords. To use traps with SNMP v 3, an SNMP v3 management application is required.

To use SNMP v3, HTTPS must be e nabled, see HTTPS, on page 42. To enable SNMP v3, check the box and provide the initial user

password.

Note

The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see

Reset to factory default settings, on page 51.

UPnP

The Axis product includes support for UPnP

.UPnP

is enabled by default and the product is automatically detected by operating

systems and clients that support this protocol.

UPnP

can be disable d under System Options > Network > UPnP

RTP/H.264

The RTP port range and multicast settings are conﬁgured under System Options > Network > RTP.

The RTP port range deﬁnes the range of ports from which the video/audio ports are auto

matically s elected. For multicast streams,

only certain IP addresses and port numbers should be used.

Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.

Bonjour

The A xis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by op erating

systems and clients that s upport this protoc

ol.

Bonjour can be disabled under System Op

tions > Network > Bonjour.

Storage

SD card

The SD card is managed on the System Options > Storage page. Click SD card to open Storage Management.

Mounting is done automatically when the card is inserted or when the product boots. SD cards are normally preformatted w hen

purchased, b ut if needed, click Format to forma t the card.

Format an SD card so that it can be written to one of two available options — VFAT and ext4. During the formatting any previous

data stored on the disk will be lost. The rec omme nded format is e x t 4, due to its res ilie nce against data los s if the card i s e jected

or if there is abrupt p ower loss. A third-party ext4 driver o r application is also n eeded to acces s the ﬁle system from Windows.

Note that most SD cards are pre-formatted with vFAT when purchased. The Check Disk option is used to check for errors on the SD

card and only works for the ﬁ le system ext4. The Repair option repairs the SD card of errors in the ﬁle system ext4. For vFAT ﬁle

system use a card re ader or PC to pe rform card maintenance.

Note

To prevent corruption of recordings, the SD c ard should always be unmounted before remo val.