User's Manual

AXIS Q1602 Network Camera
System Options
The following trap s are available:
•Coldstart
•Warmstart
•Linkup
• Authentication failed
SNMP v3 provides encryption and s ecure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNM P v3, HTTPS must be enabled, see
HTTPS, on page 35 . To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can o nly be set once. If the password is lo st, the Axis product m ust be reset to factory default, see
Reset to Factory Default Settings, on page 45 .
UPnP
TM
The Axis product includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are configured under System Options > Network > RTP.
The RTP port range defines the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always M ulticast V ideo and/or Always Multicast Audio to start multicast stream i n g with o ut op en ing an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protoc
ol.
Bonjour can be disabled under System Op
tions > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD card should a lways be unmounted before it is ejected.
The Axis product supports SD cards with the following file systems:
• ext4 — re c om m e nde d due to its resilie nce against data loss if the card is ejected or if there is abrupt pow er loss. To access
data stored on the card f rom the W indows op erating system, a third- party ext4 driver or application is required.
• vFAT — most SD cards are pre-formatted with vFAT when purchased.
If required, the SD card can be re-formatted to the desired file system. To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage and click SD Card.
41