User's Manual

AXIS Q1602 Network Camera

System Options

Port Status

The list on the System Options > Ports & Devices > Port Status page shows the status of the product’s input and output ports.

Maintenance

The Axis product provides several maintenance functions. These are available under System Options > Maintenance.

Click Restart to perform a correct restart if the A xis product is not behaving as expected. This will not affect any of the current

settings.

Click Restore to reset most settings to the factory d efa ult values. The following settings are not affected:

• the boot protocol (DHCP or static)

• the static IP address

• the default router

• the su bnet mask

•thesystemtime

• the IEEE 802.1X settings

• the focus position

Click Default to reset all settings, including the IP address, to the factory default values. This button should be used w

ith caution. The

Axis product can also be reset to factory default using the control button, see

Reset to Factory Default Settings, on page 45

To identify the product or test the Status LED, click Flash LED under Identify and specify the duration in seconds, minutes or hours.

This can be useful for identifying the p roduct among other products installed in the same location.

For information about ﬁrmw ar e upgrade, see

Upgrading the Firmware, on page 46

Support

Support Overview

The System Op tions > Support > Support Overview page provides information on troubleshooting a nd contact information,

should you require technical assistance.