User's Manual

AXIS Q1602 Network Camera
Hardware Overview
1.
Power LED
2.
Network LED
3.
Control b utton
4.
Iris connector
5.
Power connector
6.
I/O terminal connector
Connectors
For technical specifications, see page 51 .
Network connector - RJ-45 Ethernet connector. Supp orts Power over Ethernet (PoE).
NOTICE
Due to local regulations or the environmental and electrical conditions in which the p roduct is to be used, a shielded
network cable (STP) may be appropriate or req u ired. Any network cables that are routed in o utdoor environments or similar
shall be shielded (STP) and intended for their specific use. M ake sure that the network switch is properly grounded. See
for regulatory requirements.
Audio in (pink) - 3.5 mm inp
ut for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.
5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amp lifier. A stereo connector must be used for audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage.
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Co
ntrol button - The control button is used for:
5