Installation Guide

AXIS 207/207W/207MW Installation Guide Page 5
ENGLISH
LED indicators
Hardware installation
Important!
Wall mounting
1. If required, use the 3 supplied screws to fix the base
plate to a flat (horizontal or vertical) surface.
2. To use a shorter stand, unscrew the lock ring to release
the camera, and remove the extension section.
3. Attach the camera, adjust the angle and tighten the lock
ring.
Shelf mounting
1. Position the clamp and tighten the fixing screw securely.
2. Attach the clamp to the lock ring on the camera.
3. Adjust the angle and tighten the lock ring.
Wireless
Unlit Wired mode.
Green Steady for connection to a wireless network. Flashes for network activity.
Red Steady for no wireless network connection. Flashes when scanning for wireless networks.
Network
Amber Steady for connection to a 10 Mbit/s network. Flashes for network activity.
Green Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Unlit No wired network connection, or AXIS 207W/AXIS 207MW in wireless mode.
Status
Green Steady for normal operation. Can be configured to flash green at intervals whenever the
camera is accessed. See the online help for more information.
Unlit When configured for “no flash” on camera access.
Amber Steady during startup, reset to factory default and when restoring settings.
Red Slow flash for failed upgrade.
Power
Green Normal operation.
Amber Flashes green/amber during firmware upgrade.
The AXIS 207/207W/207MW is designed for indoor use only, and must always be positioned where it is not
exposed to direct sunlight or strong halogen light, which can cause permanent damage to the camera’s
image sensor. Damage as a result of exposure to strong light is not covered by the Axis warranty.