Installation Guide

USER GUIDE

NOTE:

Please read this entire manual to fully understand and safely use this product.

Specifications are subject to change without notice. Please visit www.axisep.com for the most recent user guide versions.

Included in this Box

Axis LED T8 LED Tube (plug and play), 1 PCs

User Guide, 1 Set

Important Instructions

The LED tube works directly at 100~277VAC. The installer must determine whether they have 100~277VAC at the luminaire before installation.

Installation Steps

Plug and Play procedure

1. Turn off the power to the light fixture at the breaker panel before installation.

2. Open the diffuser from the light fixture.

3. Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury.

Fluorescent light

4. Put LED tube into the lighting fixture.

plug and play LED tube

5. Install the LED tubes, close the diffuser.

6. Turn on the Power.

www.axisled.com

Toll free: 855-Axisep1 E-mail: info@axisep.com

PAGE 1
USER GUIDE NOTE: Please read this entire manual to fully understand and safely use this product. Specifications are subject to change without notice. Please visit www.axisep.com for the most recent user guide versions. Included in this Box Axis LED T8 LED Tube (plug and play), 1 PCs User Guide, 1 Set Important Instructions The LED tube works directly at 100~277VAC. The installer must determine whether they have 100~277VAC at the luminaire before installation. Installation Steps Plug and Play procedure 1.
PAGE 2
Retrofit Procedure 1. Turn off the power to the light fixture at the breaker panel before installation. 2. Open the diffuser from the light fixture. 3. Remove the fluorescent tubes. Please dispose of these items properly as they contain mercury. 4. Cut the wires shown as the diagram below. Fluorescent light 5. Make the new wire connect to branch circuit shown as the diagram below. 6. Replace the cover over the wiring channel. 7. Install the LED tubes, close the diffuser. plug and play LED tube 8.