User`s manual

7
AXIS 241Q/S/QA/SA - Product Description
DIP Switches - A corresponding line termination switch for each of the supported video
inputs. All units are shipped with the line termination enabled for each supported video
input; that is, with the DIP switches set in the down-position.
Note: If the video source is to be connected in parallel with other equipment, disable the input termination by
turning the corresponding DIP switch to the up-position (OFF). Failure to do so may cause reduced image
quality.
Control Button - Press this button to restore the factory default settings, as described in
Resetting to the Factory Default Settings, on page 53, or to install using AXIS Internet
Dynamic DNS Service (See AXIS 241Q/S/QA/SA Video Server Installation Guide).
Video Inputs - Accommodates up to 4 separate video sources (VIDEO 1 - VIDEO 4)
simultaneously. Each supported video input is connected using a coax/BNC connector.
Physical connections made using e.g. 75 Ohm coax video cable have a recommended
maximum length of 800 feet (250 meters).
Line Out (AXIS 241QA only) - Mono audio output (line level), which can be connected to a
public address (PA) system or an active speaker with a built-in amplifier. A pair of
headphones can also be attached.
Line/Mic In (AXIS 241QA only) - One 3.5mm input for a mono microphone, or for line-in
mono signal (only the left channel is used from a stereo signal).