Datasheet
AXIS 212 PTZ/AXIS 212 PTZ-V - Audio Settings
19
Audio Settings
The AXIS 212 PTZ/AXIS 212 PTZ-V can transmit audio to clients using either the built-in microphone or a
connected external microphone and can play audio received from clients via a connected speaker.
Note:
The speaker connected to the audio output must have a built-in amplifier, for example, PC speakers.
An example of a network using AXIS 212 PTZ/AXIS 212 PTZ-V cameras to transmit audio and video across the network.
This section describes how to configure the basic audio settings for the AXIS 212 PTZ/AXIS 212 PTZ-V, for
example, set the communication mode and adjust the sound levels in the microphone and speaker connected to
the camera.
Enable Audio - Check this box to enable audio in the AXIS 212 PTZ/AXIS 212 PTZ-V.
Audio Channels - Half-duplex mode transmits and receives audio in both directions, but only in one direction at a
time. This means that you must select when to receive or transmit audio with the push-to-talk button. To speak,
press and hold the button (check that the microphone is not muted). When finished speaking, release the button
and you will receive audio from the other end of the connection.
Note that the push-to-talk button is con
figured from AMC, see AXIS Media Control, on page 9. It is also possible
to configure the push-to-talk button so
that it toggles between speaking and listening modes.
When selecting S
implex - Network Camera speaker only mode, the speaker connected to the camera will play
audio, but no audio will be transmitted from the camera to other web clients. This could be used to for example,
provide spoken instructions to a person seen in the camera. This mode requires you to use the push-to-talk
button.
Simplex - Network Camera microphone only mode transmits
audio only from the AXIS 212 PTZ/AXIS 212
PTZ-V to web clients. It will not receive audio from any other web clients. This can be used in remote
monitoring, web attractions etc., to provide live audio, as well as video, of a monitored situation.
When using half-duplex, the Send the
sound from the active client to all other clients option transmits the
audio signal from the client that is talking to all the other clients.
Audio Input - Audio from an external microphone or a line source can be connected to the Audio in connector of
the AXIS 212 PTZ/AXIS 212 PTZ-V. The audio source must be set to Microphone or Line depending on the
connected device.
Client PC
TCP/IP Network
Internal
microphone
Internal
microphone